Bar Rust

Bar Rust. BarRust 235 was designed to provide excellent protection over less than ideal surface preparation The minimum standard for nonimmersion service is SSPCSP2 or ISO850112007 St2 for immersion service the minimum standard is SSPCSP6 or ISO850112007 Sa2 These minimum surface preparation standards apply to steel that has been previously abrasive.

PDF fileBarRust 231 is normally applied directly to blast cleaned steel however it can be applied over the following primers when required Cathacoat 302H Cathacoat 302HB Cathacoat 304L Cathacoat 303 Cathacoat 313 Cathacoat 304V Cathacoat 315HB Cathacoat 315 Devran 201H The following topcoats are approved for use with BarRust 231 Devran 224V Devthane.

BarRust

PDF fileBarRust 233H was designed to provide excellent protection over less than ideal surface preparation The minimum standard for nonimmersion service is SSPCSP2 or ISO850112007 St2 for immersion service the minimum standard is SSPCSP6 or ISO850112007 Sa2 These minimum surface preparation standards apply to steel that has been previously abrasive.

BarRust 235 – Specialty Coatings Inc.

BarRust 235 is a high performance multipurpose surface tolerant twocomponent chemicallycured epoxy semigloss coating For use on properly prepared steel or masonry surfaces including immersion (nonpotable water) service Ideal for structural steel piping storage tank exteriors machinery and equipment in petroleum refineries pulp and paper mills chemical and fertiliser.

BARRUST 235 PART B (REG) 0.76L (4:1)

PDF fileBarRust 233H Epoxy may be applied in one coat up to 625 microns (25 mils) wet to obtain 500 microns (20 mils) dry See NSF listing for details For airless spray application A 451 pump ratio or larger is recommended Ideally fluid hoses should not be less than 3/8″ ID and not longer than 50 feet to obtain optimum results For longer fluid hoses ID should be 1/2″ Longer hose length.